Contact  |  Delivery  |  Terms  |  Help Section

Click to see our video tutorial on replacing a topside overlay / sticker:



Upper control or topside panels decals / front faces often need replacing due to cracking if you allow water to run through the cracked inlay, the buttons on the upper control panel can become damaged and a new upper control panel may be required.

Fundamentally they are all the same, below we have produced a step by step guide for carrying out the work, please note hot tubs do differ and subtle changes in the configurations may change the work steps shown.

These instructions are for informational purposes only. Poolandspacentre.co.uk does not guarantee that following these instructions will resolve your specific spa condition, nor does poolandspacentre accept liability for work performed by anyone attempting the repair or part replacement.

By the way a cracked graphic inlay will not cause the digital display to become dim or go blank. When that happens, it's time to replace the upper control panel.

Begin to peel 1. Lift up the corner and begin to peel.
2. Peel carefully. peel carefully
ink left behind

3. The clear film comes off in several pieces,
leaving the vinyl ink behind.
4. Carefully remove the graphic ink with a
plastic spatula or your fingernail.		 remove ink
Clean
5. Completely remove the graphic ink and clean the
surface with isopropyl alcohol and a cotton wool bud.

6. Remove the protective liner on the back (if applicable)		 remove liner from new overlay
place on topside
7. Lay the bottom of the graphic inlay on the ridge of the
upper control panel, center and lay the rest of the inlay down.
8. Firmly press in place. firmly press in place

Any further questions, please ring us on 0844 800 3290.