0844 800 3290

Mon - Fri
9am - 5pm

---

• 
• 
• 
• 
• 
• 

These are HI-FLO specialist side discharge pumps identified by the code 310-1160SD on the wetend front faceplate, all the options have 2 inch (inlet) x 2 inch (outlet).

This European spec. motor (EMG)  is recommended by Waterway for the European market, It has a rear fan and a finned body design to dissipate heat.

There are both 1 and 2 speeds available in 48 frame.

	1 Speed	2 Speed
Length:	360 mm	360 mm
Height:	195 mm	220 mm
Width:	175 mm	175 mm

	2HP - Single Speed	2HP - Two Speed
Amps:	6	2.2 (low) / 6.8 (high)
Volts:	230	230
Hz:	50	50
Motor KW:	1.4	0.44 (low) / 1.48 (high)
HP:	1.5	0.63 (low) / 2.11 (high)
Impellor:	1.5hp (310-0800)	1.5hp (310-0800)
RPM:	2820	1440 (low) / 2850 (high)
Capacitor:	25uf	16uf (low) / 30uf (high)
Fittings:	2" x 2" inch	2" x 2" inch

The pumps are supplied without a cable, as the power cord is dedicated to your model of control system, therefore you will need to rewire your existing cable to the pump. Remove the cord from your old pump, and note, the wire colour going to high speed or low speed terminals on any motor, the colour is set or determined by the maker of the spa control, not by the pump or motor manufacturer.

Before you remove the power cord from your old pump, look at the old motor wiring label and make a note of what color goes to high, and to low. Then, put the cord on your new motor/pump, using the same color for high as on the old motor and also for low speed wiring.

We have used and fitted this pump as replacement of the Chinese DXD 320 pump - it is an exact match in terms of unions - outlets and power specification -please always ring us to discuss on 0844 800 3290