0844 800 3290

Mon - Fri
9am - 5pm

---

---

---

• 
• 
• 

**This is a most unusual pump, please ring prior to ordering as there is a lead time

These are single and two speed side discharge pumps, all the options have 1.5 inch (inlet) x 1.5 inch (outlet).

This European spec. motor (EMG)  is recommended by Waterway for the European market, It has a rear fan and a finned body design to dissipate heat.

There are both 1 and 2 speeds available in 48 frame with a 1.5hp and 2hp option on each.

	1 Speed	2 Speed
Length:	380 mm	380 mm
Height:	200 mm	220 mm
Width:	175 mm	175 mm

	1.5HP - Single Speed	1.5HP - Two Speed	2HP - Single Speed	2HP - Two Speed
Amps:	6	2.2 (low) / 6.8 (high)	6	2.2 (low) / 6.8 (high)
Volts:	230	230	230	230
Hz:	50	50	50	50
Motor KW:	1.4	0.44 (low) / 1.48 (high)	1.4	0.44 (low) / 1.48 (high)
HP:	1.5	0.63 (low) / 2.11 (high)	1.5	0.63 (low) / 2.11 (high)
Impellor:	1.5hp (310-0800)	1.5hp (310-0800)	2hp (310-0810)	2hp (310-0810)
RPM:	2820	1440 (low) / 2850 (high)	2820	1440 (low) / 2850 (high)
Capacitor:	25uf	16uf (low) / 30uf (high)	25uf	16uf (low) / 30uf (high)
Fittings:	1.5 x 1.5 inch	1.5 x 1.5 inch	1.5 x 1.5 inch	1.5 x 1.5 inch

The pumps are supplied without a cable, as the power cord is dedicated to your model of control system, therefore you will need to rewire your existing cable to the pump. Remove the cord from your old pump, and note, the wire colour going to high speed or low speed terminals on any motor, the colour is set or determined by the maker of the spa control, not by the pump or motor manufacturer.

Before you remove the power cord from your old pump, look at the old motor wiring label and make a note of what color goes to high, and to low. Then, put the cord on your new motor/pump, using the same color for high as on the old motor and also for low speed wiring.