Shipping FREE on all orders over £75 - 
This is a Waterway 48 frame wet end with a 2" Suction inlet and a 2.5" discharge outlet.
To ensure correct specification of the suction outlet, measure over the threads and look at the diagram below to ensure a match.
To ensure correct frame size, measure the following for a 48 frame wet end.
On the rear of the wet end, if you look closely you will see P/N 315-1220 as shown in the title pictures, this designates the front and rear volute (the plastic casing).
Height: 230mm
Width: 200mm (face diameter)
Depth: 145mm
If you look very carefully (difficult to see) through the centre suction hole at your existing impellor centre (near off centre), you may see a 3hp or 4hp stamped into the ceramic impellor, these different impellor sizings can be selected through the drop down box above.
If you can't find it don't worry, we will send you the factory standard for the UK - 4hp impellor all you will get is more umff in the water coming from the jets.
Internally factory fitted are the seal kit to fit 48 frame motors.
To ensure correct specification of the suction outlet, measure over the threads and look at the diagram below to ensure a match.
To ensure correct frame size, measure the following for a 48 frame wet end.
On the rear of the wet end, if you look closely you will see P/N 315-1220 as shown in the title pictures, this designates the front and rear volute (the plastic casing).
Height: 230mm
Width: 200mm (face diameter)
Depth: 145mm
If you look very carefully (difficult to see) through the centre suction hole at your existing impellor centre (near off centre), you may see a 3hp or 4hp stamped into the ceramic impellor, these different impellor sizings can be selected through the drop down box above.
If you can't find it don't worry, we will send you the factory standard for the UK - 4hp impellor all you will get is more umff in the water coming from the jets.
Internally factory fitted are the seal kit to fit 48 frame motors.