RWA™ Swing Coverlifter

Industry leading Hot Tub Coverlifters through Rock Water Air (RWA™), built with quality, reliability, functionality and longevity in mind, a quick and easy way to remove you cover safely and easily. You may find cheaper, but we price competitively with the quality assured.

Check out the video in the galley above so you can see how the lifter works.

RWA™ Swing Coverlifter is by far the most popular model of lifter on the market. It is simple to install and is stable and sturdy. Made of 100% rust resistant aluminium alloy with black powder coating

Require 10"-15" of clearance behind spa and 5" on each side.

Step 1: Connect the Pivot Arm and two Bushings to the Mounting Brackets, using one Hex Cap Bolt, two Flat Washers, and one Nylon Locknut, press the decorative Large Black Dome Caps over the heads of the Hex Cap Bolts, as shown in the below picture. Then attach the Mounting Brackets to the left and right sides of the spa with the Mounting Screws.

Note: If necessary, slide the Wrench behind the Mounting Bracket to tighten the Nylon Locknut.

Step 2: Insert the Support Arms into the Centre Coupler Piece. Then join the Support Arms Section into the Pivot Arms.

Step 3: Lay the Cover Lift on the spa cover. Position①, using the Self Tapping Screws to fasten the Support Arms and Coupler Piece together. Position②, using the Self Tapping Screws to fasten the Support Arms to the Pivot Arms. Then press the decorative Small Black Dome Caps over the heads of all the exposed screws.

If you cover is ridiculously heavy, then don't use a coverlifter to solve the issue you need a new Hot Tub Cover, which we also lead the market in (blow our own trumpet), if you don't eventually the cover lifter will fail, which is not covered under warranty. A quick tip for saving you cover, water evaporates from the surface of the spa settling on the underside of the cover; the chemically treated water then gradually damages/burns the sheathed core material. In time the sheathing breaks down allowing water vapour to gain entry to the core insulation, causing the lid to gain in weight.

Cleaning the lid underside with a light amount of spa surface cleaner and a soft washing brush before rinsing thoroughly with a hose, will reduce both the chemical attack and the mildew which grows and builds up on the damp vinyl which if you let continue will begin to rot the fabric, accelerating failure.

If you don't leave your lid open for 30 minutes and run the jets after adding shock or high levels of sanitiser then, microscopic holes will burn the core sheath allowing water to ingress into the core, eventually making the lid too heavy to lift.

Due to the size and weight of this item, if you purchase 2 or more on the same invoice, you may be contacted for additional shipping fees. Please refer to our terms and conditions.