JavaScript seems to be disabled in your browser. For the best experience on our site, be sure to turn on Javascript in your browser.
Call Us: 01746 330950
01746 330950Contact us on: 01746 330950
From £8.83 £7.36
To £258.25 £215.21
6 In stock
Available for Back Order
* Required Fields
£8.83 £7.36
In-stock orders dispatched:14:00
Please note this pump comes disassembled and requires 5 minutes and a spanner to put together
This is our best selling 48 frame pump, we are a primary distributer for Waterway in the UK and all the options here have a 1.5 inch (inlet) x 1.5 inch (outlet).
The actual measurement over the threads of the inlet and outlet is approx 61mm
These European spec. motor (EMG) are recommended by Waterway for the European market, there are both single and two speed variants available in either 1.5hp or 2hp power outages
They have a rear fan and a finned body design to dissipate heat and give lower running temperatures.
The pumps are supplied without a cable, as the power cord is dedicated to your model of control system, therefore you will need to rewire your existing cable to the pump. Remove the cord from your old pump, and note, the wire colour going to high speed or low speed terminals on any motor, the colour is set or determined by the maker of the spa control, not by the pump or motor manufacturer.
Before you remove the power cord from your old pump, look at the old motor wiring label and make a note of what color goes to high, and to low. Then, put the cord on your new motor/pump, using the same color for high as on the old motor and also for low speed wiring.
Please note if your pump is the red one shown in the photo above then this is the option for you - just pick whether it is 1 or 2 speed - the horse is dependant on the amp draw.
If you need help with anything please see Hot Tub Pump Identification
Max file size: 6 Mb
Follow us on
